Replacement Parts And Accessories - Maytag NEPTUNE Installation Instructions Manual

ELECTRIC MODELS – U. S . O n ly
Most U. S. d rye r s, as manu factured, require a 120/240 volt, 60 Hz AC approved electrical serv i c e. Some require
120/208 volt, 60 Hz approved electrical serv i c e. The electric service requirements can be found on the data
label located on the front behind the door. A 30 ampere fuse or circuit breaker on both sides of the line is
r e q u i r e d .
A 120/240 volt U.S. electric dryer must be converted if it is to operate on a 120/208 volt electrical system.
A heating element conversion kit is available (see Accessories).
If a power cord is used, the cord should be plugged into a 30 ampere receptacle.
The power cord is NOT provided with U.S. electric model dr yers.
IMPORTANT: When permitted by local codes, the dryer electrical supply may be connected by means of a
new power supply cord kit, marked for use with clothes dryer, that is U.L. listed, rated at 120/240 volts
minimum, 30 amperes with three No. 10 copper wire conductors terminated with closed loop terminals, open-
end spade lugs with turned up ends or with tinned leads.
Do not reuse a power supply cord from an old dryer. The power cord electric supply wiring must be retained
at the dryer cabinet with a suitable UL listed strain relief.
If the dr yer is to be installed in a mobile home or an area where local codes do not permit grounding through
neutral, only a 4 conductor power cord, rated and terminated as above, may be used.
ELECTRIC MODELS – Canada Only
A 120/240 volt, 60 Hz AC approved electrical service fused through a 30 ampere fuse or circuit breaker on
both sides of the line is required.
All Canadian models are shipped with the power cord attached. The power cord should be plugged into a
30 ampere receptacle.
NOTE: It is not permissible to convert a dryer in Canada to 208 volts.

REPLACEMENT PARTS AND ACCESSORIES

If your dryer requires replacement parts or accessories, contact the dealer from whom you purchased your
dryer or Maytag Customer Service, Box 2370, Cleveland, Tennessee 37320-2370, phone 423-472-3333, for
information on the nearest authorized Maytag Parts Distributor.