Ducati Multistradia 1200S ABS Touring Owner's Manual page 167

The height of the headlight beam can be adjusted using the
adjusting screws (1, fig. 160) located at the bottom on the
E
sides of the headlight. Turning the screw (1) of the headlight
clockwise, the light beam will move downwards: turning it in
the opposite direction, will move it upwards. The side
position of the headlight can be adjusted using the adjusting
screws (2) located at the centre on the upper part of the
headlight. Turning the screws (2) on the left side of the
headlight clockwise, the light beam will move to the right:
turning it in the opposite direction, will move it to the left. To
move the light beam in the same manner, turn the screw (2)
on the right side of the headlight, inverting the direction of
rotation.
Warning
The headlight might fog up if the vehicle is used under
the rain or after washing.
Switch headlight on for a short time to dry up any
condensate.
166
2
1
2
1
1
fig. 185