JVC GR-DVL505 Instructions Manual page 73

Indications
SET DATE/TIME!
LENS CAP
A. DUB ERROR!
A. DUB ERROR!
<CANNOT DUB
ON AN LP RECORDED
TAPE>
<CANNOT DUB
ON A 16BIT
RECORDING>
<CHECK TAPE'S ERASE
PROTECTION SWITCH>
INSERT ERROR!
INSERT ERROR!
<CANNOT EDIT
ON AN LP RECORDED
TAPE>
<CHECK TAPE'S ERASE
PROTECTION SWITCH>
MEMORY IS FULL
COPYING FAILED
NO IMAGES STORED
E01 — E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
Appears when the date/time is not set.
Appears when the built-in clock battery runs out and the
previously set date/time is erased. Consult your nearest JVC dealer
for replacement.
Appears for 5 seconds after power is turned on if the lens cap is attached.
Appears if Audio Dubbing is attempted on a blank portion of a tape.
Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode.
Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio.
Appears if A. DUB (e) on the remote control is pressed when the erase
protection tab is set to "SAVE".
Appears if Insert Editing is attempted on a blank portion of a tape.
Appears if Insert Editing is attempted on a tape recorded in the LP mode.
Appears if INSERT (w) on the remote control is pressed when the erase
protection tab is set to "SAVE".
Appears when the built-in memory is full and shooting is not possible.
Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
Appears if the built-in memory is full when dubbing still images recorded
on the tape to the built-in memory.
Appears in the following cases when dubbing still images stored in the
built-in memory to a tape:
– when condensation occurs.
– when no tape is loaded.
– when the erase protection tab is set to "SAVE".
– when a tape in another format is loaded.
– when the tape ends.
Appears if there are no images stored in the built-in memory when the
Power Switch is set to "
The error indications (E01 — E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest JVC dealer.
Function
" and the VIDEO/DSC Switch is set to "
73
EN
( pg. 11)
( pg. 60)
( pg. 60)
( pg. 60)
( pg. 60)
( pg. 61)
( pg. 61)
( pg. 61)
( pg. 49)
( pg. 48)
".