Setting The Rinse Aid Dosage - Miele Standard Operating Instructions Manual

Before using for the first time

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
The dosage can turn out to be higher
than the set value due to the automatic
adjustment of the "Sensor wash"
programme.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
28
^ Switch the dishwasher off with the
On/Off button K.
^ Press the Start/Stop button in and,
whilst holding it in, switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button three
times.
The Delay start indicator will flash
briefly 3 times at intervals.
p 3 will flash in the display.
This means that the rinse aid dosage
has been set to 3 ml at the factory.
The dosage set will appear in the
display after the p.
^ Use the Start/Stop button to select
the rinse aid dosage you want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off with the
On/Off button K.