How To Turn The Radar On/Off And Transmit - Furuno 1835 Operator's Manual

1. DESCRIPTION OF OPERATION
1.2

How to Turn the Radar On/Off and Transmit

Press the
the key until the screen turns off.
When you turn on the power, the initialization screen appears followed by the start-up
screen. The start-up screen shows the model name, program number and the results
of the ROM and RAM check, OK or NG (No Good). If NG appears, contact your dealer
for instruction.
XX Program version no.
After the self-tests are completed, the bearing scale and a digital timer appear. The
digital timer counts down time necessary to warm the magnetron, which transmits the
radar pulses. The time to warm the magnetron takes 90 sec.
After the timer reads 0:00, the STBY screen appears. The STBY screen has three
types. (See section 1.44.2.) The radar is ready to transmit the radar pulses. Press the
STBY/TX key to transmit the radar pulses.
The STBY/TX key switches between standby and transmit. The antenna rotates in
transmit and is stopped in standby. The magnetron gets old with use. To increase the
life of the magnetron, set the radar in standby when you do not use the radar.
Quick start
If the magnetron is still warm, you can get the radar to TRANSMIT without the warm-
up time. When the
seconds after you turn off the power.
1-2
key to turn on the radar. To turn off the radar, press and hold down
-
Start-up screen
key is turned off by accident, turn on the
Model name appears here.
key within 10