Assigning A Procedure (Operating Steps) To A Key - Siemens HiPath 2000 Operating Instructions Manual

Step by Step
Program/Service
>
*
91=Prog. feature key?
US: Change feature?
UK: Change key?
>
Procedure key?
Redial
US: Save entry?
UK: Save?
>
Previous?
>
Key label?
US: End?
UK: Exit?
Assigning a Procedure (Operating
Steps) to a Key
Station numbers and functions which require additional
inputs, i.e. comprise several operating steps, can be
saved to a single key on your telephone.
Using the associated dial function, for example
! Page 52, you can save all the remaining inputs re-
quired (station number of the calling party + the station
number to be dialed) to a single key.
Station numbers which require additional inputs but
also dial pauses can also be stored.
Press the key. The LED lights up.
:
Select and confirm.
or
qme
Enter the code.
Press the key. If a function has already been assigned to
this key, a corresponding message is displayed.
:
Confirm.
:
:
Confirm.
o
Enter the procedure, e.g. "*67 231 089123456".
*67= code for associated dial
231= station number of the calling party
089123456 = number to be dialed.
If necessary
To insert pauses, press this key (a "P" is displayed).
:
Confirm.
:
or If you make a mistake:
:
Select and confirm. This deletes all digits entered.
If applicable
:
Select and confirm to update automatic key labeling.
For more information, see ! Page 120.
:
Confirm.
:
Saving Functions, Procedures and Appointments
69