Audio Dubbing; Insert Editing - JVC GR-D650US Instructions Manual

Audio Dubbing

The audio track can be customized only when
recorded in the 12-BIT and SP modes.
( pg. 32)
Use the provided remote control.
Speaker
START/
STOP
PAUSE
PLAY
REW
STOP
INSERT
A.DUB
1
Play back the tape to locate the point where
editing will start, then press PAUSE (8).
2
While holding A. DUB (
control, press PAUSE (8). The "8
appears.
3
Press PLAY (3), then begin "narrating".
Speak into the microphone.
To pause dubbing, press PAUSE (
4
To end Audio Dubbing, press PAUSE (8),
then STOP (7).
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX".
( pg. 31, 35)
NOTES:
Sound is not heard from the speaker during Audio
Dubbing.
When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are recorded
separately.
If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
If you change from 12-BIT to 16-BIT in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-BIT recording began.
During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes
recorded in 16-BIT audio or a blank portion, Audio
Dubbing stops.
Stereo Microphone
) on the remote
" indicator
8
).

Insert Editing

You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points. The original audio remains
unchanged.
Use the provided remote control.
NOTES:
Before performing the following steps, make sure
that "TIME CODE"" in both Recording and
Playback Menus is set to "ON". (
Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1
Play back the tape, locate the Edit-Out point
and press PAUSE (8). Confirm the time code at
this point. ( pg. 21)
2
Press REW (1) until the Edit-In point is
located, then press PAUSE (8).
3
Press and hold INSERT (
control, then press PAUSE (8). The "8
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4
Press START/STOP to begin editing.
Confirm the insert at the time code you checked in
step 1.
To pause editing, press START/STOP. Press it
again to resume editing.
5
To end Insert Editing, press START/STOP,
then STOP (7) on the remote control.
NOTES:
Program AE, Effects and Shutter Effects
( pg. 41) can be used to spice up the scenes
being edited during Insert Editing.
During Insert Editing, the date and time
information changes.
If you perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. (
EDITING
45
EN
pg. 31, 34, 35)
) on the remote
"
pg. 49)