Chopping - Silvercrest SMZ 260 B2 Operating Instructions Manual

Chopping

Note
Before using the appliance for the first time, clean it
thoroughly as per the instructions given in the chapter
"Cleaning".
³
Place the bowl 6 in the appliance base 9.
³
Place the blade holder 5 with the knife 7 on
the mounting 8.
³
Prepare the items to be processed by cutting lar-
ge pieces to a size that will fit in the bowl 6.
³
Place the food to be processed in the bowl 6.
Thereby, take note of the following table:
Filling
Foodstuff
quantity
Salami 130 g 3 x 5 secs.
Cheese
(Gouda,
100 g 4 x 15 secs.
young,
refrigerator
temperature)
Onions
100 g
Garlic
Carrots 100 g 3 x 5 secs.
Dried fruit 130 g 4 x 15 secs.
Almonds 50 g
Eggs
150 g 2 x 4 secs.
(hard boiled)
Walnuts 50 g
Ice cubes 100 g
Processing
SPEED
time
Turbo
Turbo
pulsating Turbo
Normal
Turbo
coarse:
1 x 10 secs.
middle:
Turbo
2 x 10 secs.
fine:
3 x 10 secs.
Turbo
2 x 8 secs. Turbo
pulsating Turbo
³
Close the bowl 6 with the lid 4: Place it on the
bowl 6 so that the lugs on the lid 4 engage in
the slots on the bowl 6. Then turn the lid 4 so
that the lugs slide unter the slots and the lid 4
locks into place.
³
Place the motor block 2 on the lid collar 3.
³
Press the motor block 2 downwards, as shown
in Figure B. The motor starts with the normal
operating speed.
³
To make use of the higher processing speed
"Turbo", press, in addition to the motor block 2,
the turbo button 1 and keep it pressed down,
as shown in Figure C.
Note
Should larger pieces of the contents collect on the
wall of the bowl while processing, lift the motor
block 2 from the lid collar 3. Shake the bowl 6
vigorously and then continue with the processing.
Before the processing, particularly hard foods must
be cut into smaller pieces (about 2cm). Otherwise,
the motor could block. With hard foodstuffs select a
pulsating processing. For this, press the turbo button
1 repeatedly for a short time (in addition to the
motor block 2). Should the foodstuff not be com-
pletely pulverised, you can either cut it into smaller
pieces or lift the motor block 2 from the lid col-
lar 3. Shake the bowl 6 vigorously and then con-
tinue with the processing.
³
When the contents have been sufficiently chopped,
release the motor block 2 and, if necessary, the
turbo button 1.
³
Unplug the power cable from the socket.
- 4 -