Buzzer
The buzzer can be programmed for the following functions:
– a continuous tone at the end of a program, and/or
– an error signal that beeps in 1-second intervals.
The numbers shown in the display correspond to the following settings:
100
Buzzer off
101
End of program (factory setting)
102
Fault
103
End of program + Fault
Step
^ Press the "Drying" 3 button until E01 appears in the
display.
^ Turn the program selector to "Drain".
^ Press and hold the "Display" ß button until the
required value appears in the display, e.g., 103.
Value selected:
The buzzer will sound for 30 sec during the selected setting.
To switch it off earlier:
– Turn the program selector to f.
– Press the "Display" ß button.
– Interrupt the power supply, e.g., open the door.
Programming functions
Display / Result
E01
100 to 103
103
37