Overview Of Startup Procedure - Motorola MVME167 Series Installation Manual

Hardware Preparation and Installation

Overview of Startup Procedure

3
Stage
1 Prepare the MVME167.
2 Prepare the chassis.
3 Install your MVME167 in the chassis.
3-2
The following list identifies the things you will need to do before
you can use this board, and where to find the information you need
to perform each step. Be sure to read this chapter and all Caution
notes, and have the related documentation with you before you
begin.
Table 3-1. Startup Overview
What you will need to do...
Ensure that EPROM devices are properly
installed in their sockets.
ConÞgure adapters and MVME712X
transition modules.
Install/remove jumpers on headers.
Turn power off to chassis and peripherals.
Disconnect AC power cable.
Remove chassis cover.
Remove Þller panels from card slots.
Remove IACK and BG jumpers from
backplane.
Slide the module into the chassis and
fasten it securely.
Refer to...
page...
Preparing the
Hardware
Checking the
167Bug EPROMs
The userÕs manual you
received with your
MVME712X module
Jumper Settings
Preparing the
MVME167 for 3-13
Installation
The userÕs
manual you
3-13
received with
your chassis
Installing
Transition
Modules and
3-15
Adapter Boards
On
3-5
3-7
3-7