Adjusting The Volume - Yamaha Disklavier Operation Manual

2
Press [PLAY/PAUSE] to continue
normal playback.
Press [STOP] to engage Pause
mode.
If you fast forward a song all the way to the
end, Pause mode is engaged. Pressing
[PLAY/PAUSE] starts playback of the next
song.
If you reverse a song all the way to the
beginning, Pause mode is engaged.
Pressing [PLAY/PAUSE] starts playback
from the beginning.

Adjusting the Volume

You can adjust the playback volume with the
Control Unit or with the remote control as
described below. Since all piano songs are
recorded at the maximum volume level of 0,
volume can be decreased down to –10, the softest
volume at which the piano can play.
For Ensemble songs, the volume of the piano and
internal XG tone generator are adjusted
simultaneously, so it is a good idea to first balance
the volume of the piano and XG tone generator.
☛ See "Balancing the Ensemble Volume (TG Master
Balance)" on page 21.
The LED volume level indicators show volume
levels in the manner shown below. For example,
when two consecutive indicators are lit, the
volume level is between these two levels.
LED
Volume
-10 -8 -6 -4 -2 0
0
-1
-2
-3
-4
-5
Note: Make sure the VOLUME knob on the
Amplifier is set to an appropriately audible
level. If the VOLUME knob on the Amplifier
is turned fully counterclockwise, no sound
may be produced even when you adjust the
volume on the Control Unit.
Once you set the volume of the Amplifier, you
do not need to adjust it frequently.
The volume level setting is saved when another
song is selected, another disk inserted or selected,
or when the Disklavier is turned off.
Note: This setting does not affect manual playing.
LED
Volume
-10 -8 -6 -4 -2 0
-6
-7
-8
-9
-10
19