Pioneer SGY-PM910H User Manual page 13

6.
Tap [Search].
The search for the sensor starts.
A [Searching. Please wait.] message
appears.
7.
Check the information about
the sensor.
Information about the sensors appears
when the sensors are found.
Check the following items.
• [Device Number]
Make sure that the device number
is the same as the device number
of the transmitter.
• [Error Rate]
Make sure that "OK" is displayed.
• The device numbers are printed on
the right junction box and on the
side of the left sensor. Refer to the
Installation Manual for details.
Pairing with the Cyclocomputer
• If the numbers that are displayed on
[Device Number] are different from
the transmitter device numbers,
specify the device numbers to pair
with the sensor.
Refer to the User's Guide of the
Cyclocomputer SGX-CA500
regarding how to specify a device
number to pair a sensor.
• If "Processing..." is displayed in the
[Error Rate] area, the information
from the sensor is not being received
correctly because transmission
conditions are bad. Make sure
that the sensor you are pairing is
activated, then bring the SGX-CA500
closer to the sensor and perform the
pairing operation again.
• Pairing with the sensor may not
be possible due to the influence
of the 2.4 GHz frequency band. If
"Processing..." is displayed even if
the SGX-CA500 is moved closer
to the sensor and paired with it, try
again someplace where there is no
interference from microwaves, radio
waves, or wireless equipment.
Pairing of the right transmitter is
completed.
Next, pair the left transmitter.
EN
13