Basic Recording - JVC GR-AXM226 Instructions Manual

14
EN
Power Switch
Recording Start/Stop Button
2 5M I N
MIN 120MIN
(Now calculating)
0MIN 1MIN
(Blinking) (Blinking)
90
180
–
– – – – – – – 6 – – –
BR I GHT
To Adjust The Brightness Of The LCD Monitor
.... rotate the BRIGHT Wheel until the bright
level indicator on the display moves and
the appropriate brightness is reached.
: Suitable for standard recording using NO special effects or manual adjustments.
: Allows you to set recording functions using the menus for more creative capabilities.
OFF : Switches off the camcorder.
: Allows you to play back your recordings.
During shooting
Tape remaining
time indicator
(Approximate)
119MIN
2MIN 3MIN
(Blinking)
BRIGHT Wheel
+
Power Switch Position
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Power ( pg. 6)
Load A Cassette (
Recording Mode Setting (
Tape Length Setting (
Grip Adjustment (
Viewfinder Adjustment (
Shooting While Watching The Viewfinder
1
Make sure the LCD monitor is closed and locked.
Press in the tabs on the lens cap to remove it. Set the
Power Switch to "
lights and the camcorder enters the Record-Standby
mode. "PAUSE" is displayed in the viewfinder.
2
Press the Recording Start/Stop Button. "
in the viewfinder while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
Shooting While Watching The LCD Monitor
1
Make sure the LCD monitor is fully open. Press in the
tabs on the lens cap to remove it. Set the Power
Switch to " " or "
the camcorder enters the Record-Standby mode.
"PAUSE" is displayed in the LCD monitor.
2
Tilt the LCD monitor upward/downward for best
viewability and press the Recording Start/Stop Button.
" " appears in the LCD monitor while recording is
in progress.
NOTE:
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfinder instead.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.

Basic Recording

pg. 13)
pg. 11)
pg. 12)
pg. 8)
pg. 8)
" or " ". The power lamp
". The power lamp lights and
" appears