Table of Contents
Advertisement
3.2.4.3 Input Type (Process)
ENTER INPUT TYPE MENU:
Press a
Press d
Press d
PROCESS SUBMENU:
Press b
Press d
Press d
Press b
Press d
Process Types: 100 mV
Display:
For 4 to 20 mA Input select 0 to 20 mA then adjust the Input/Reading accordingly.
To adjust 4 to 20 mA input, see example under INPUT/READING Submenu.
The factory preset value is 4 to 20 mA.
1) Press a, if necessary until CNFG prompt appears.
2) Display advances to INPT Input Menu.
3) Display flashes T.ç , RTD or PROC (Thermocouple, RTD or
Process). If the displayed input type is PROC , press a to skip
to step 6 ( PROC stops flashing).
4) Scroll through the available selection to PROC (flashing).
5) Display shows STRD stored message momentarily and then
PROC (not flashing).
6) Display flashes previous Process type selection i.e. 0-10
(see below for Process types selection).
7) Scroll through the available Process types to the selection of
your choice.
8) Display shows STRD stored message momentarily and then
advances to the RDG Reading Configuration Menu.
1 V
0-0.1
0-1.0
10 V
0 to 20 mA
0-10
0-20
19
Advertisement
Table of Contents
