Setpoints - Newport i8-AL Operator's Manual

3.2.2 Set Points Menu
SETPOINT 1:
Press a
Press d
Press b & c
Holding b & c buttons down for approximately 3 seconds will speed up
the rate at which the Setpoint value increments or decrements.
Press b & c
Press d
SETPOINT 2:
Press d
Press b & c
Holding b & c buttons down for approximately 3 seconds will speed up
the rate at which the Setpoint value increments or decrements.
Press d
Setpoints are used for Deviation only.
1) Press a, if necessary until SP1 prompt appears.
2) Display shows previous value of "Setpoint 1".
3) Press b and c to increase or decrease Setpoint 1
respectively.
4) Continue to use b and c to enter your 4-digit Setpoint 1
value.
5) Display shows STRD stored message momentarily and then
advance to SP2 only, if a change was made, otherwise press
a to advance to SP2 Setpoint 2 Menu.
6) Display shows previous value of "Setpoint 2".
7) Press b and c to increase or decrease Setpoint 2
respectively.
8) Display shows STRD stored message momentarily and then
advance to CNFG only, if a change was made, otherwise press
a to advance to CNFG Configuration Menu.
15