Samsung NX-N2 User Manual page 57

2
Using "PCoIP"
Display Topology Tab
To apply the Display Topology
you must have the PCoIP host software installed on the host. Refer to the "PCoIP Host Software for
Windows User Guide: TER0810001" for more details.
The Display Topology
For details about the
client, refer to the "PCoIP Host Software for Windows User Guide: TER0810001".
Always change the
Options
Figure 2-24: Display Topology
Enable Configuration

The device can be configured with display position, rotation and resolution settings if enabled.
The settings are saved when you click
Display Layout

Select whether you want a horizontal or vertical layout for your displays (A and B). This setting should
reflect the physical layout of the displays on your desk.
Horizontal: Select to arrange A and B horizontally, with A located to the left of B.

Vertical: Select to arrange A and B vertically, with A located above B.

A maximum of two displays can be enabled at the same time.
feature to a PCoIP session between a zero client and a PCoIP host,
tab has no corresponding menu in the Administration Web Interface.
Display Topology feature for a PCoIP session between a host card and a zero
Display Topology settings using the
User Settings interface.
Configuration
Apply
Display Topology
or OK and are applied when the device is reset.
tab on the zero client OSD
57
2 Using "PCoIP"