Samsung NX-N2 User Manual page 33

2
Using "PCoIP"
Network Tab
You can configure the host and client network settings from the
After you update the parameters on this page, click
The Network parameters can also be configured using the Administrative Web Interface.
Figure 2-3: Network
Enable DHCP

When Enable DHCP
address, subnet mask, gateway IP address and DNS servers. When disabled, the device requires
these parameters to be set manually.
IP Address

The IP address of the device. If DHCP is disabled, you must set this field to a valid IP address.
If DHCP is enabled, you cannot edit this field.
Subnet Mask

The subnet mask of the device. If DHCP is disabled, you must set this field to a valid subnet mask.
If DHCP is enabled, you cannot edit this field.
It is possible to configure an illegal IP address/subnet mask combination (e.g., invalid mask)
making the device unreachable. Ensure you set the subnet mask properly.
Gateway

The gateway IP address of the device. If DHCP is disabled, this field is required. If DHCP is enabled,
you cannot edit this field.
Primary DNS Server

The primary DNS IP address of the device. This field is optional. If the DNS server IP address is
configured using the Connection Manager, the address may be set as an FQDN instead of an IP
address.
Configuration
is enabled, the device will contact a DHCP server to be assigned an IP
Initial Setup page or
Apply to save your changes.
Network page.
33
2 Using "PCoIP"