Playback Using The Remote Control - JVC 0104-FO-ID-PJ Instructions Manual

Playback Using The Remote Control

The Full-Function Remote Control Unit can operate this
camcorder from a distance as well as the basic
operations (Playback, Stop, Pause, Fast-Forward and
Rewind) of your VCR. It also makes additional playback
functions possible. ( pg. 16)
Installing The Battery
The remote control uses one
lithium battery (CR2025).
1
Pull out the battery holder
by inserting a pointed
instrument into the slot.
2
Insert the battery in the
holder, and be sure to have
the "+" mark visible.
3
Slide the holder back in
until you hear a click.
Beam Effective Area
(indoor use)
When using the remote control,
be sure to point it at the remote
sensor. The transmitted beam's
approximate effective distance
for indoor use is 5 m (16 ft).
NOTE:
The transmitted beam may not be
effective or may cause incorrect
operation when the remote sensor
is directly exposed to sunlight or powerful lighting.
2
3
1
1
Slot
Remote sensor
Buttons And Functions
A
Infrared beam transmitting window
The following buttons are available only when the
camcorder's Power Switch is set to "PLAY".
B
AUDIO Button ..................................... (
C
PAUSE Button* .......................................... (
Up Button .................................................. (
D
SLOW Rewind Button ................................ (
E
REW Button* ....................................... (
Left Button ................................................ (
F
INSERT Button .......................................... (
G
STOP Button* ...................................... (
Down Button ............................................. (
H
SHIFT Button ............................................ (
I
EFFECT ON/OFF Button .......................... (
J
EFFECT Button ........................................ (
K
SLOW Forward Button............................... (
L
FF Button* ........................................... (
Right Button .............................................. (
M
PLAY Button* ....................................... (
N
A. DUB Button ........................................... (
O
DISPLAY Button ................................. (
The following buttons are available when the camcorder's
Power Switch is set to "A" or "M".
a
S.SHOT (Snapshot) Button*
b
START/STOP Button*
c
Zoom (T/W) Buttons** ........................ (
* Functions the same as each corresponding button on the
camcorder. ( pg. 51)
** Functions when the camcorder's Power Switch is set to
"PLAY" as well.
VIDEO PLAYBACK
EN
T
W
pg. 25, 28)
pg. 16)
pg. 16)
pg. 16)
pg. 14, 20)
pg. 16)
pg. 37)
pg. 14, 20)
pg. 16)
pg. 16)
pg. 16)
pg. 16)
pg. 16)
pg. 14, 20)
pg. 16)
pg. 14, 20)
pg. 37)
pg. 17, 34)
pg. 12, 16)
15