Listening To The Radio - Sony XAV-68BT Operating Instructions Manual

4
Touch [Pairing].
The unit enters pairing standby mode.
5
Perform the pairing procedure on the
BLUETOOTH device to detect this unit.
6
Select "SONY:XAV-68BT" shown in the
display of the BLUETOOTH device.
7
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "passcode," "PIN code,"
"PIN number," "password," etc., depending on the
BLUETOOTH device.
8
Select this unit on the BLUETOOTH device
to establish the BLUETOOTH connection.
or lights up when the connection is made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected by another device. To enable
detection, terminate the current connection.
Connecting with a paired BLUETOOTH
device
This chapter explains how to connect manually to
registered BLUETOOTH devices.
1
Make sure that the BLUETOOTH signals
both on this unit (page 18) and the
BLUETOOTH device are activated.
on the status bar indicates that the
BLUETOOTH signal on this unit is on.
2
Operate the BLUETOOTH device to
connect to this unit.
or appears.
When the ignition is turned to on with the
BLUETOOTH signal activated, this unit searches for
the last-connected BLUETOOTH device, and
connection is made automatically if possible.
Note
If this unit cannot detect the last-connected
BLUETOOTH device, touch [Reconnect] to search for the
last-paired device again.
If the problem is not solved, follow the pairing
procedure.
To install the microphone
To capture your voice during handsfree calling, you
need to install the microphone (supplied).
For details on how to connect the microphone, refer
to the supplied "Installation/Connections" guide.
8
GB

Listening to the Radio

Listening to the Radio
To listen to the radio, press HOME then touch
[Tuner].
Reception controls/indications
 
 
Reception controls ( to )

Current band icon
Opens the band list.

[PTY] (Program Types) (FM only)
Opens the PTY list (page 10).

[ZAP] (ZAPPIN™)
Helps to find a desired station by listening to
preset stations for a few seconds.

Opens the tuner option menu.

/
Tunes in automatically.

/
Tunes in manually.
Touch and hold to continuously skip
frequencies.

[1] to [6]
Selects a preset station.
Touch and hold to store the currently
displayed frequency in that preset.
Reception indications ()
 Frequency
  
  