Erasing Point Data - Yamaha RCX240 User Manual

4-axis robot controller
Hide thumbs Also See for RCX240:
Table of Contents

Advertisement

Enter the point number range.
2
Use
to
the point number for the copy destination in the following format.
"(copy start number) – (copy end number), (copy destination number)"
For example, to copy the data between P30 and P34 onto the lines after P50, enter "30
- 34, 50".
n
NOTE
Valid point numbers are from 0 to 9999.
Press
3
A confirmation message appears on the guideline.
Copying point data (2)
Press
(YES) to make a copy.
4
The point data in the selected range is copied onto the data lines starting from the
specified copy destination number.
Press
(NO) if you want to cancel the copy.
11.2.6

Erasing point data

Press
(ERASE) in "MANUAL>POINT" mode.
1
The message "Erase (####-####)>" appears on the guideline.
Erasing point data (1)
,
and
to enter the point number range for the copy source and
.
11. "MANUAL" mode
Chapter 4 OPERATION
1
2
3
4
5
6
7
8
9
10
4-103

Advertisement

Table of Contents
loading

Table of Contents