Isuzu 1999 RODEO Workshop Manual page 532

Rodeo 1999
Hide thumbs Also See for 1999 RODEO:
Table of Contents

Advertisement

24. Remove two bolts and nut then remove timing belt
front cover.
25. Remove ventilation hose from cylinder block side and
from cylinder head side.
26. Remove two bolts, ignition cable cover and remove
ignition cables from spark plug.
27. Disconnect camshaft angle sensor connector.
28. Remove ten bolts and remove cylinder head cover.
29. Remove fixing bolt of timing belt tensioner then
remove timing belt tensioner.
30. Remove timing belt.
CAUTION:
f Do not bend or twist belt, otherwise its core could
be damaged. The belt should not be bent at a
radius less than 30 mm.
f Timing belt drive gear counterhold with J–42620.
ENGINE MECHANICAL (X22SE 2.2L)
f Do not allow oil or other chemical substances to
come in contact with the belt. They will shorten
the life.
f Do not attempt to pry or stretch the belt with a
screw driver or any other tool during installation.
f Store timing belt in cool and dark place. Never
expose the belt direct sunlight or heat.
31. Remove two idle pulleys, the left side with idle pulley
bracket.
32. Remove two bolts and stud bolt and remove timing
belt rear cover.
33. Remove camshaft angle sensor
34. Disconnect engine oil pressure switch connector.
020RW014
35. Remove camshaft assembly exhaust side.
36. Use J–42623 to remove ten cylinder head fixing bolts
020RW010
6A–23
050RW005
012RW007

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents