Removal; Installation - Isuzu 1999 RODEO Workshop Manual

Parking Brake Lever Assembly and Associated Parts
Legend
(1) Rear Console
(2) Switch Connector
(3) Bolt
(4) Adjust Nut and Lock Nut

Removal

1. Remove rear console (1).
f Refer to Body and Accessories section.
2. Disconnect switch connector (2).
3. Remove bolt (3).
4. Remove adjust nut and lock nut (4).
5. Pull out equalizer (6) from trunnion pin (5).
6. Disconnect trunnion pin (5) from Parking brake lever
(8).
7. Disconnect parking brake rear cable (7).
Parking Brake Lever and Front Cable
PARKING BRAKE SYSTEM (4x4 Model)
(5) Trunnion Pin
(6) Equalizer
(7) Parking Brake Rear Cable
(8) Parking Brake Lever

Installation

1. Apply grease (BESCO L–2 or equivalent) to the
connecting portion of the rear cable (7) and equalizer
(6).
2. Connect parking brake rear cable (7) to equalizer
3. Install trunnion pin (5) to parking brake lever (8).
4. Insert equalizer (6) into trunnion pin (5) and tighten
adjust nut and lock nut (4).
f To adjust the parking brake lever, see "Parking
Brake Adjustment" in this section.
Lock Nut Torque: 13 N·m (113 lb in)
5. Tighten the parking brake lever fixing bolt (3) to the
specified torque.
Torque: 15 N·m (11 lb ft)
6. Connect switch connector (2).
7. Install rear console (1).
f Refer to Body and Accessories section.
5D1–3
311RW008