Inspection; Installation - Isuzu 1999 RODEO Workshop Manual

4. Remove heater unit.
f Refer to Heater Unit in this section.
5. Remove duct.
6. Remove case (Mode control) and do not remove link
unit at this step.
7. Remove case (Temperature control) separate two
halves of core case.
8. Remove heater core (1).
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–15
9. Pull out the mode door while raising up the catch of

Inspection

Check for foreign matter in the heater core, stain or the
core fin defacement.
860RS002

Installation

To install, follow the removal steps in the reverse order,
noting the following point:
1. Check that each mode door operates properly.
860RS003
the door lever.
860RS004