Isuzu 1999 RODEO Workshop Manual page 371

4D–36 TRANSFER CASE
31. Install plate (11), ball (10) and bearing collar (9).
32. Install needle bearing (8) and input gear (7).
33. The clutch hub face (with the heavy boss) must be
facing the transfer input gear side (55).
34. Install high–low clutch hub and sleeve (6), using a
bench press.
35. Install input shaft assembly (5) to transfer case (42).
(A/T)
36. Install the snap ring (4) to the transfer case (42). (A/T)
NOTE: The snap ring must be fully inserted into the
transfer case snap ring groove.
37. Install the front companion flange temporarily and use
the flange holder J–8614–11 and lock nut wrench
J–37219 to install the lock nut (3).
Torque: 137 N·m (101 lb ft)
38. Use the punch to stake the lock nut (3) at one spot.
39. Use a suitable drift and hammer to install the ball
bearing (2).
40. Install bearing snap ring (1).
226RW158
226RW137
226RS079