Isuzu 1999 RODEO Workshop Manual page 360

9. Remove needle bearing (8).
10. Remove bearing collar (9).
11. Remove ball (10).
12. Remove plate (11).
13. Use a bench press and the ball bearing remover
J–22912–01 to remove the ball bearing (12) from the
input shaft (13). (A/T)
14. Use a pair of snap ring pliers to remove the bearing
snap ring (14).
15. Use a plastic hammer to tap the front output gear
assembly (15) free.
226RS071
16. Remove bearing snap ring (16).
17. Use a bench press and the bearing remover
J–22912–01 to remove the following parts.
18. Remove ball bearing (17), and bearing collar (18).
Remove sub–gear snap ring (19), spacer (20),
belleville spring (21), and sub–gear (anti–lash plate)
(22). (M/T)
Remove front output gear (23) and needle bearing
(24).
265RS002
19. Remove inside ring (25).
20. Remove outside ring (26).
21. Remove block ring (27).
22. Use a bench press and bearing remover J–22912–01
to remove 2WD–4WD clutch hub and sleeve
assembly (28) and stopper plate (29).
NOTE: Do not reuse the stopper plate.
TRANSFER CASE 4D–25
262RS009
262RS010