3D–10 REAR SUSPENSION
Upper Link and Associated Parts
Legend
(1) Bolt and Nut (Axle side)
(2) Rubber Plate
Removal
1. Remove fuel tank. Refer to Engine Fuel in Engine
section.
2. Remove the speed sensor cable from the upper link.
3. Remove bolt, nut, rubber plate and protector.
4. Remove upper link.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Upper link
2. Rubber bushing
f Remove the rubber bushing by using remover
J–xxxxx–x.
Upper Link
(3) Upper Link
(4) Protector (Left side only)
(5) Bolt (Frame side)
460RW006
901RW158