15-42 ELECTRICAL SYSTEM
Ignition System
IC Igniter Installation
•
Insert the projection [A] on the IC igniter into the hole [B]
in the IC igniter bracket.
IC Igniter Inspection
•
Remove the IC igniter (see IC Igniter Removal).
•
The IC igniter can be checked by using either the igniter
checker or hand tester.
(1) Igniter Checker.
•
Use the igniter checker [A] to check the condition of the
IC igniter [B].
Special Tool - Igniter Checker: 57001-1378
○
Connect a 12 V battery [C] to the checker.
○
Select the specified harness [D] (57001-1381) in the ig-
niter checker instruction manual.
•
Check the ignition, over-rev limiter, side stand interlock,
and signal output for tachometer functions.
Replace the IC igniter if any function is defective.
Read the Transistor Igniter Checker Instruction be-
fore checking.
(2) Hand Tester:
•
Set the hand tester to the × 1 kΩ range and make the
measurements shown in the table.
Special Tool - Hand Tester: 57001-1394
If the tester readings are not as specified, replace the IC
igniter.
Use only the hand tester (57001-1394) for this test.
A tester other than the Kawasaki Hand Tester may
show different readings.
If a megger or a meter with a large-capacity battery
is used, the IC igniter will be damaged.
CAUTION
CAUTION
Comments to this Manuals
Latest comments: