Download  Print this page

Hub Bearing; Hub Bearing Removal; Hub Bearing Installation - Kawasaki EN500 Vulcan 500 LTD Service Manual

Motorcycle.
Hide thumbs

Advertisement

Table of Contents

Hub Bearing

Hub Bearing Removal

Remove the wheel, and take out the following.
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does
not touch the ground.
Front
Grease Seal [A]
Circlips [B]
Speedometer Gear Drive [C]
Special Tool - Inside Circlip Pliers: 57001-143
Rear
Coupling [A]
Collar [B]
Brake Panel
Circlip [C]
Take the bearings [A] out of the hub, using the bearing
remover.
Special Tools - Bearing Remove Shaft: 57001-1265 [B]
Bearing Remover Head,
-1267 [C]

Hub Bearing Installation

Before installing the hub bearings, blow any dirt or foreign
particles out of the hub with compressed air to prevent
contamination of the bearings.
Replace the bearings with new ones.
Install the front bearings in the following sequence.
Press in the left side bearing [A] until it is bottomed.
Special Tool - Bearing Driver Set: 57001-1129
Insert the collar [B] in the hub [C].
Press in the right side bearing [D] until it is bottomed.
Press in the rear bearings until they are bottomed.
Special Tool - Bearing Driver Set: 57001-1129
Install the bearings so that the marked side or sealed
side faces out.
Replace the circlips with new ones.
Special Tool - Inside Circlip Pliers: 57001-143
CAUTION
15 ×
NOTE
17: 57001
WHEELS/TIRES 9-13

Advertisement

Table of Contents

   Also See for Kawasaki EN500 Vulcan 500 LTD

This manual is also suitable for:

Vulcan 500 ltd

Comments to this Manuals

Symbols: 0
Latest comments:
  • Ricardo Paluan Apr 27, 2016 01:22:
    Adquiri recentemen​te uma moto vulcan 500 ano 1995. Tenho o 37 anos e iniciante no mundo motociclis​ta. Entretanto​, em razão só tempo e idade da moto, não tenho o manual do proprietá​rio, sendo este indispens