Download  Print this page

Advertisement

4-28 ENGINE TOP END
Valves
Lap the valve to the seat, once the seat width and O.D.
are within the ranges specified above.
Put a little coarse grinding compound on the face of the
valve in a number of places around the valve head.
Spin the valve against the seat until the grinding com-
pound produces a smooth, matched surface on both the
seat and the valve.
Repeat the process with a fine grinding compound.
[A] Lapper
[B] Valve Seat
[C] Valve
The seating area should be marked about in the middle
of the valve face.
If the seat area is not in the right place on the valve, check
to be sure the valve is the correct part. If it is, it may have
been refaced too much; replace it.
Be sure to remove all grinding compound before assem-
bly.
When the engine is assembled, be sure to adjust the valve
clearance (see Valve Clearance Adjustment).

Advertisement

Table of Contents

   Also See for Kawasaki EN500 Vulcan 500 LTD

This manual is also suitable for:

Vulcan 500 ltd

Comments to this Manuals

Symbols: 0
Latest comments:
  • Ricardo Paluan Apr 27, 2016 01:22:
    Adquiri recentemen​te uma moto vulcan 500 ano 1995. Tenho o 37 anos e iniciante no mundo motociclis​ta. Entretanto​, em razão só tempo e idade da moto, não tenho o manual do proprietá​rio, sendo este indispens