Honda AQUATRAX R-12X 2005 Owner's Manual page 141

8. Apply a thin coat of engine oil to the
rubber seal (6) of a new oil filter.
(6)
(6) oil filter rubber seal
9. Install the new oil filter and tighten it by
hand.
10.Using an oil filter wrench attachment
and a torque wrench, tighten the new oil
filter to the specified torque:
· ·
20 lbf ft (26 N m, 2.7 kgf
11. Install the oil drain pipe cap.
Add Engine Oil:
12. Fill the oil tank with the recommended oil
·
m)
Engine Oil & Filter
slowly (page 124).
If the oil filter was replaced, use
approximately:
• ARX1200T2
4.5 US qt (4.3 )
• ARX1200N2
4.3 US qt (4.1 )
If the oil filter was not replaced, use
approximately:
• ARX1200T2
4.4 US qt (4.2 )
• ARX1200N2
4.2 US qt (4.0 )
Servicing Your Honda
(cont'd)
133