Download  Print this page

Cover Installation; Right Engine Cover Disassembly - Kawasaki KX85 Service Manual

Hide thumbs
Also See for KX85
Brochure - 13 pages
Service manual - 332 pages
Owner's manual - 172 pages


Right Engine Cover
Remove the right engine cover bolts [A] and take off the
right engine cover [B] and gasket.

Cover Installation

There are two knock pins of the mating surfaces of the
crankcase and right engine cover.
Apply molybdenum disulfide grease [A] to the water pump
shaft [B] to prevent water pump seal damage.
If the right engine cover is installed without greas-
ing the pump shaft, the pump seal could damage.
Turn the clutch release lever toward the rear.
Stick the new right engine cover gasket in position with a
thin layer of grease.
Torque - Right Engine Cover Bolts: 8.8 N·m (0.90 kgf·m, 78
KX85-A4 ∼/B4 ∼, KX100-D4 ∼
Apply a non-permanent locking agent to the thread of
lever assy mounting screw.
Install the spring to the lever shaft, put the one end of
spring into the notch of the lever shaft, and install the
collar, lever assy and washer with the specified torque.
Torque - Lever Assy Mounting Screw: 6.4 N·m (0.65 kgf·m,
56 in·lb)
Push [A] the shaft lever [B], and install the link lever [C] to
the valve shaft [D].


Table of Contents

   Also See for Kawasaki KX85

This manual is also suitable for:


Comments to this Manuals

Symbols: 0
Latest comments:
  • Julie Williams Jul 17, 2019 11:44:
    Can you please help me identify two engine years by the engine number and not the vin?

    1. KX085AE037​876

    2. KX085AE015​215

    Any help would be greatly appreciate​d.

    Thank you. Julie.
  • jeesus Jun 10, 2015 09:46: