2-16 FUEL SYSTEM
Remove the air cleaner element, and separate the ele-
ment [A] from the frame [B].
Clean the element in a bath of a high flash-point solvent,
and squeeze the element dry.
Check all the parts of the element for visible damage.
If any part of the element is damaged, replace it.
After cleaning, saturate the element with a high-quality
foam-air-filter oil, squeeze out the excess, then wrap it in
a clean rag and squeeze it as dry as possible. Be careful
not to tear the sponge filter.
Assemble the element.
Air Cleaner Housing Removal
Air Cleaner Duct Clamp (loosen)
Rear Frame Pipe [A]
Air Cleaner Housing Bolts [B]
Remove the air cleaner housing [C] to the right side.
Air Cleaner Housing Installation
Installation is the reverse of the removal.
Torque - Rear Frame Pipe Bolts [D]: 34 N·m (3.5 kgf·m, 25
Air Cleaner Housing Mounting Bolts: 8.8 N·m
(0.90 kgf·m, 78 in·lb)
Air Cleaner Housing Assembly
Install the air cleaner duct [A] so that the lobe [B] of it faces
to the left side and aligns with the left bolt of the housing.
Air Cleaner Duct [A]
Lobe of the duct [B]
Air Cleaner Housing [C]
Projection (show the hole which is assembled to the left
Left Bolt [E]