Table of Contents
Advertisement
Chapter 2: Getting Connected
Configuring from a
remote PC
24
If you want to configure the appliance from a remote computer, follow
the procedure below, which explains how to connect to the appliance
using Hyperterminal. You may use another terminal emulation program,
such as PuTTY, to connect to the appliance, but those procedures are not
outlined here.
To connect to the appliance remotely using Hyperterminal:
1. On your computer, select Start
Communications.
2. Select Hyperterminal.
3. Create a new connection using the following settings:
Setting
Communications Port
Emulation
Bits per second
Data bits
Parity
Stop bits
Flow control
4. Press
to establish a connection.
ENTER
When the connection is established, the Proventia Setup
Configuration Menu appears.
If you are unable to establish a connection, make sure the
Tip:
appliance has power and that you have started the appliance.
5. Go to "Completing the Initial Configuration" on page 26.
>
>
Programs
Value
Typically COM1
(depending on computer
setup)
VT100
9600
8
None
1
None
IBM Internet Security Systems
>
Accessories
Advertisement
Table of Contents
