Frigidaire Dryer Servicing page 78

Affinity & gallery series 5.8 cu. ft. gas & electric dryers
Hide thumbs Also See for Dryer:
Table of Contents

Advertisement

Section 4 Component Teardown
Gas Valve Wire Harness Connections
(All Gas Models)
To remove the wire harness connections:
1. Disconnect the dryer from electrical supply, then
remove the top panel, rear panel, console, front
panel, front inner panel and drum.
2. Label the connections as needed prior to
disconnecting.
3. Disconnect at the Molex connectors for the ignitor,
sensor and main wire harness.
(See Figure 4-41)
4. Disconnect wire leads from gas valve coil terminals.
Gas Valve Coil Removal (All Gas Models)
The gas valve coils are secured by a bracket that has
two screws fastened into the gas valve body. Small
plastic pins locate the coils for proper
alignment.
To remove the gas valve coils:
1. Disconnect the dryer from electrical supply, then
remove the top panel, rear panel, console, front
panel, front inner panel and drum.
2. Disconnect the two wire harness leads from the gas
valve coil terminals.
3. Using a #2 Phillips head screwdriver, extract two
screws securing the coil bracket to the valve body.
Remove bracket from valve body. (See Figure 4-42 )
4. Pull coils from valve body.
4-16
To Gas Valve
Coils
To Ignitor
To Sensor
Figure 4-41.
Screws
DO NOT
GRIP
HERE
Figure 4-42.
To
Control
Plastic Coil
Pins

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Affinity seriesGallery series

Table of Contents