Towing The Vehicle - Mercedes-Benz E320 Operator's Manual

Important!
5. Start engine of the vehicle with
the charged battery and run at
high idle. Make sure the cables
are not on or near pulleys, fans,
or other parts that move when
the engine is started. Allow the
discharged battery to charge a
few minutes. Start engine of the
disabled vehicle in the usual
manner.
6. After the engine has started, remove
jumper cables by exactly reversing
the above installation sequence,
starting with the last connection
made first. When removing each
clamp, make sure that it does not
touch any other metal while the
other end is still attached.
Important!
A discharged battery can freeze at
approx. +14°F (-10°C). In that case, it
must be thawed out before jumper
cables are used. A frozen battery can
explode and cause personal injury.
Jumper cable specifications:
• Minimum cable cross-section of
2
25 mm or approx. 2 AWG
• Maximum length of 11.5ft. (3.5 m).

Towing the Vehicle

The rear towing eye is located at the
right, below the bumper. The front
towing eye is located on the passenger
side behind a flap in the bumper panel.
Flap removal:
Insert finger in recess of flap and pull
flap out.
Flap installation:
Engage flap at bottom and press in top
securely.
We recommend that the vehicle be
transported using flat bed equipment.
This method is preferable to other types
of towing.
The vehicle may be towed with all
wheels on the ground and the selector
lever in position "N" for distances up to
30 miles (50 km) and at a speed not to
exceed 30 mph (50 km/h). The
electronic key must be in steering lock
position 2.
To positively avoid a possibility of
damage to the transmission, however,
we recommend to disconnect the drive
shaft at the rear axle drive flange on
any towing beyond a short tow to a
nearby garage.
Do not tow with sling-type equipment.
Towing with sling-type equipment over
bumpy roads will damage radiator and
supports.
Use wheel lift, dolly, or flat bed
equipment, with electronic key in
steering lock turned to position 0.
113