Attention:
NEVER switch the scooter into free wheel when you are parked on
a slope: the scooter will start moving down the slope as a result of
gravity.
If the Fortress 1700 DT/TA is in the free wheel position:
It is not possible to drive the scooter.
•
The electronics can be switched on, but the motor cannot drive the scooter.
•
In this situation, the electronics should be switched off.
To be able to drive the Fortress 1700 DT/TA again, the following steps should
be carried out:
Switch the free wheel lever into the Brake Engage position.
•
Switch the scooter on by inserting the jack key into the jack key receptacle.
•
Now, you are able to drive the Fortress 1700 DT/TA again.
4.6
Disassembling the scooter for storage and/or transport
To be able to store the Fortress 1700 DT/TA in a small space or transport it in
a smaller vehicle suitable for this purpose, the scooter can be disassembled.
This way, it will take up less space. The steps to disassembling your Fortress
1700 DT/TA are as follows.
4.6.1
Removing the seat
See Fig. 000000120 (seat may differ
•
slightly from diagram)
The seat should be removed as follows:
Unlock the turning mechanism of the
•
seat by pushing the seat lock lever
toward the front of the scooter.
Lift the seat from the seat post.
•
The seat is easily lifted out if it is
•
turned slightly in the process.
Folding the backrest completely
•
forward reduces the size of the seat
and can make it easier to lift from its
post.
34
Fortress 1700 DT/TA
A
000000120