Inserter Mode (Optional) - Toshiba e-studio550 Operator's Manual

6. INSERTER MODE (OPTIONAL)

When you want to insert paper or use the staple or the hole punch functions without making copies, place
the paper of the same size and direction in the optional inserter.
- If the sheets of paper are fed from more than one paper source (Drawer, External LCF, Bypass guide,
Inserter), set them all in the same size and direction.
Paper Acceptable to Set in the Inserter
Paper size A3, A4, A4-R, B4, B5, FOLIO, LD, LG, LT, LT-R, COMP
Paper type Plain paper (60 - 80g/m
Special paper (OHP film, Color paper, Hole punch paper, etc.)
(Ask your authorized Toshiba dealer for the details of acceptable special papers.)
Maximum 60 - 80g/m
capacity more than 80 - 256g/m
(Special paper 7mm or less)
* The above paper may not be acceptable due to paper quality, etc.
* When the paper set in the inserter is used for the staple or the saddle stitch, it is specified respectively.
- Staple Page 6-5
- Saddle stitch Page 6-7
1 Place the paper in the inserter (optional) and align
the slides to its size.
- Place paper in face up.
- For paper with a different top and bottom, place it in the same
direction as that of original.
- Place the paper so that it does not extend beyond the line of
indication shown on the slides.
- When placing large paper, extend the tray as shown on the
right.
2 ), Thick paper (more than 80 - 256g/m
2 : 100 sheets
2
: Loading height 16mm or less
Setting Paper
2 ), Recycled paper,
Slide
1
2
3
4
5
6
7
8
9
10
11
12
6-9