Download  Print this page

Clutch Cable Removal; Clutch Cable Installation; Clutch Cable Lubrication And Inspection - Kawasaki KX65 Service Manual

Hide thumbs

Advertisement

5-6 ENGINE RIGHT SIDE
Clutch Cable

Clutch Cable Removal

Slide the dust cover out of place.
Loosen the adjusting nuts at the lower of the cable, and
turn the adjusting nuts to give the cable plenty of play.
Loosen the knurled locknut [A] at the clutch lever, and
screw in the adjuster [B].
Line up the slots [C] in the clutch lever, knurled locknut,
and adjuster, and then free the cable from the clutch lever.
Free the clutch inner cable tip from the clutch release
lever.
Do not remove the clutch release shaft unless it is
absolutely necessary. If removed, release shaft oil
seal must be replaced with a new one.
Pull the clutch cable out of the frame.

Clutch Cable Installation

Run the clutch cable according to the Cable, Wire and
Hose Routing section of the General Information chapter.
Adjust the clutch cable (see Free Play Adjustment).

Clutch Cable Lubrication and Inspection

Lubricate the clutch cable [A] using the pressure cable
lubber in accordance with the Periodic Maintenance
Chart.
With the cable disconnected at both ends, the cable
should move freely within the cable housing (see Appen-
dix chapter).
NOTICE

Advertisement

Table of Contents

   Also See for Kawasaki KX65

Comments to this Manuals

Symbols: 0
Latest comments: