Advertising

Advertising

Professional Digital Two-Way Radio System
Repeater
Installation Guide
DR 3000 Repeater

Advertising

   Also See for Motorola DR 3000

   Related Manuals for Motorola DR 3000

   Summary of Contents for Motorola DR 3000

  • Page 1

    Professional Digital Two-Way Radio System Repeater Installation Guide DR 3000 Repeater...

  • Page 2: Computer Software Copyrights

    No duplication or distribution of this document or any portion thereof shall take place without the express written permission of Motorola. No part of this manual may be reproduced, distributed, or transmitted in any form or by any means, electronic or mechanical, for any purpose without the express written permission of Motorola.

  • Page 3

    Product Safety and RF Exposure booklet enclosed with each radio (Motorola Publication part number 6866537D37) to ensure compliance with Radio Frequency (RF) energy exposure limits. For a list of Motorola-approved antennas and other accessories, visit the following web site which lists approved accessories for your radio model: http://www.motorola.com/governmentandenterprise...

  • Page 4: Table Of Contents

    Table of Contents Table of Contents Foreword ......................i Product Safety and RF Exposure Compliance .....................i Computer Software Copyrights ........................i Document Copyrights ...........................i Disclaimer..............................i Trademarks ..............................i Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards .............ii Repeater Model Numbering Scheme............vi Chapter 1 Pre-Installation Considerations .........

  • Page 5: Table Of Contents

    Appendix A Replacement Parts Ordering..........A-1 Warranty and Service Support ...................... A-1 European Radio Support Centre (ERSC)..................A.2 Piece Parts ............................ A.3 Technical Support.......................... A.3 Further Assistance from Motorola ....................A.3 Related Publications DR 3000 Basic Service Manual....................6866576D03 June 12, 2007 6866576D02...

  • Page 6

    List of Figures List of Figures Figure 4-1 Locations of External Connectors at Rear of Repeater ............4-1 Figure 4-2 Making Connections to a Backup Battery ................4-2 June 12, 2007 6866576D02...

  • Page 7

    Repeater Model Numbering Scheme Repeater Model Numbering Scheme Model No.Example : Position Unique Model Variations AZ: Asia/Australia N: Standard Package LA: Latin America AA: North America (except Mexico) MD: Europe/Middle East/Africa Version Letter Repeater Feature Level 1: Mini-U MOTOTRBO Repeater 2: BNC Model Series 7: Rack Mount...

  • Page 8: Chapter 1 Pre-installation Considerations, Installation Overview, Environmental Conditions At Intended Installation Site, Operating Temperature Range

    If this is the first time installing this type of equipment, it is highly recommended that the user read: • this entire installation section before beginning the actual installation, and • the Motorola Quality Standard Fixed Network Equipment Installation manual, R56 (6881089E50), specifically refer to the information on ground connection for lightning protection.

  • Page 9: Humidity, Air Quality, Equipment Ventilation, Ac Input Power Requirements, Circuit Overloading, Equipment Mounting Methods

    Pre-Installation Considerations: Equipment Ventilation 1.2.2 Humidity Not to exceed 95% relative humidity @ 50°C (122°F). 1.2.3 Air Quality For equipment operating in an environmentally controlled environment with repeater(s) rack mounted, the airborne particle level must not exceed 25 µg/m³. For equipment operating in an area which is not environmentally controlled (repeater(s) cabinet mounted), air borne particle level must not exceed 90 µg/m³.

  • Page 10: Site Grounding And Lightning Protection, Electrical Ground, Rf Ground, Lightning Ground

    NOTE: Motorola recommends the following reference source: Motorola Quality Standards Fixed Network Equipment Installation Manual R56……………………...……………........6881089E50 1.6.4...

  • Page 11

    Pre-Installation Considerations Notes June 12, 2007 6866576D02...

  • Page 12: Chapter 2 Mechanical Installation, Unpacking Equipment

    - 13.4 cm (5.25 inches) high Two mounting rails 5 cm (2 inches) from front cabinet with front mounting holes 5.7 cm (2.25 inches) apart (center to center). Contact Motorola Technical Support for specific question regarding mounting equipment in customer-supplied cabinets.

  • Page 13

    Mechanical Installation: Transferring Equipment from Shipping Container to Rack or Cabinet Notes June 12, 2007 6866576D02...

  • Page 14: Chapter 3 Indicators And Connectors, Front Panel, Led Indicator Descriptions

    Chapter 3 Indicators and Connectors Front Panel 3.1.1 LED Indicator Descriptions Status Description Solid GREEN Repeater powered by AC Power Solid RED Repeater powered by backup battery Repeater powered off Solid RED Repeater function disabled Repeater Blinking RED Repeater in self-test mode Disable Repeater in normal operational mode Digital...

  • Page 15: Rear Panel, Rear Panel Parts

    Indicators and Connectors Rear Panel 3.2.1 Rear Panel Parts Item Description RX Connector Type BNC-F Power Supply On/Off Turns on or off the power to the repeater from both AC input Switch and backup battery. If the switch is off, the repeater will not switch to battery operation.

  • Page 16: Chapter 4 Electrical Connections, Ac Input Power Connection

    Chapter 4 Electrical Connections After the MOTOTRBO Repeater has been mechanically installed, electrical connections must be made. This involves making the following connections: • to power supply via AC power cord, and to • antenna coax cables Figure 4-1 shows the position of the repeater external connectors and line cord located on the back panel.

  • Page 17: Ground Connection, Battery Backup Connection

    The repeater is equipped with a ground screw located on the rear of the repeater. Connect the ground screw to the site ground point. Refer to Motorola Quality Standards Fixed Network Equipment Installation Manual R56 (6881089E50), for complete information regarding lightning protection.

  • Page 18: Rf Antenna Connections, Duplexer Selection, Antenna Selection

    The antenna must be connected to the duplexer with a high grade 50 Ohm transmission line (Heliax). The line must have connectors to match the connectors on the duplexer and antenna. For proper antenna installation, please also consult the Motorola Quality Standards Fixed Network Manual R56 (6881089E50). Equipment Installation It is important that all antenna cables are grounded at the point they enter the building.

  • Page 19

    Electrical Connections: RF Antenna Connections Notes June 13, 2007 6866576D02...

  • Page 20: Chapter 5 Post-installation Checklist, Applying Power, Verifying Proper Operation, Front Panel Leds

    Chapter 5 Post-Installation Checklist After the MOTOTRBO Repeater has been mechanically installed and all electrical connections have been made, power may now be applied and the repeater checked for proper operation. Applying Power Before applying power to the repeater, make sure all boards are securely seated in the appropriate connectors on the backplane and that all RF cables are securely connected.

  • Page 21

    Post-Installation Checklist: Archiving Notes June 12, 2007 6866576D02...

  • Page 22: Technical Support

    In instances where the product is covered under a "return for replacement" or "return for repair" warranty, a check of the product should be performed prior to shipping the unit back to Motorola. This is to ensure that the product has been correctly programmed or has not been subjected to damage outside the terms of the warranty.

  • Page 23

    Some replacement parts, spare parts, and/or product information can be ordered directly. If a complete Motorola part number is assigned to the part, it is available from Motorola Radio Products and Solutions Organization (RPSO). If no part number is assigned, the part is not normally available from Motorola.

  • Page 24

    EMEA Regional Warranty, Service and Technical Support: Technical Support Motorola Product Services is available to assist the dealer/distributors in resolving any malfunctions which may be encountered. North Europe - Stephen Woodrow Central and East Europe - Siggy Punzenberger Telephone: +44 (0) 1256 488 082...

  • Page 25

    EMEA Regional Warranty, Service and Technical Support: August 14, 2007 6866576D02...

  • Page 26

    MOTOROLA and the Stylized M Logo are registered in the U.S. Patent and Trademark Office. All other product or service names are the property of their respective owners. © 2007 Motorola, Inc. All rights reserved. June 2007 . www.motorola.com/mototrbo @6866576D02@...

Comments to this Manuals

Symbols: 0
Latest comments:
  • khairuddin Oct 25, 2015 06:23:
    I want to DR 3000 Installati​on Manual and doplexar Installati​on
  • Edmond Irwin Nov 20, 2014 11:47:
    Dear Sir/Madam
    ​Need informatio​n on how to utalise the GPS option of the MOTOTRBO DM3600, what is needed to to display the relevent data.
    Rega​rds.

    Edmo​nd