Latch Assembly Removal
1.
Position System Unit Power switch to Off, unplug System Unit
power cord, and disconnect all cables from rear of
System Unit.
2.
Set Display, Keyboard, and Printer away from System Unit
~
working area.
3.
Remove System Unit cover (See page 3-98).
4.
Remove Diskette Drive Logic Printed Circuit Board
(See page 3-24).
5.
Close latch and lightly hold cone lever arm down while
removing latch mounting screws.
6.
Lift latch inhibitor out of Diskette Drive.
7.
Slide latch assembly out through slots in rear of front panel.
Mounting Screws
-=::::::::;:::f'
I
I
I
.!,
.!,
Latch Inhibitor
Latch Assembly
3-20