Washer Location - GE WSLP1500 Owner's Manual & Installation Instructions

BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
for local inspector's use.
IMPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – 1 hour
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
Note –
• This appliance must be properly grounded,
and electrical service to the washer must conform
with local codes and ordinances and the latest
edition of the National Electrical Code, ANSI/NFPA 70.

WASHER LOCATION

Washer must be installed on firm flooring to minimize
vibration during spin cycles. Concrete flooring is best,
but wood base is sufficient providing floor support
meets FHA standards. Washer should not be installed
on rugs or exposed to the weather.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the
weather.
ELECTRICAL
This appliance must be supplied with the voltage and
frequency indicated on the rating plate (located on
the back of the washer) and connected to an
individual, properly grounded branch circuit, protected
by a 15- or 20-amp circuit breaker or time-delay fuse.
Installation Instructions
Save these instructions
Observe all governing
Be sure to leave these
Keep these instructions
PLUMBING
• WATER PRESSURE
150 p.s.i. maximum dynamic pressure measured at
faucet.
• WATER TEMPERATURE
heater should be set to deliver water at 120° to
150°F (50° to 66°C) IN THE WASHER when HOT wash
is selected.
• SHUT-OFF VALVES
valves (faucets) should be supplied.
• DRAIN
set tub. The discharge height MUST NOT BE LESS
THAN 30" nor more than 8' above the base of the
washer. The standpipe must be 1
diameter and must be open to the atmosphere.
RACK INSTALLATION
• Ensure washer is centered between the rack sides.
PARTS SUPPLIED
Water Hoses (2)
TOOLS REQUIRED
Pliers
13
" minimum inside
1 2
Drain Hose