Chapter 1 - Dk14 Installation; Inspection; Packaging And Storage; Site Requirements - Toshiba DK14 Installation And Maintenance Manual

DK14 Installation
This chapter explains how to install the Strata DK14 system. It includes information on site
requirements, wiring diagrams, and step-by-step instructions on how to install the unit(s), the
ground wiring, AC power cabling, reserve power (battery backup) cabling, and PCB cabling.

Inspection

1. When the system is received, examine all packages carefully and note any visible damage. If
any damage is found, do not open the packages. Contact the delivery carrier immediately and
make the proper claims.
2. After unpacking (and before installing), check the system against the packing list and inspect
all equipment for damage. If equipment is missing or damaged, contact your supplier
immediately.
3. Be sure to retain original packaging materials for re-use when storing or transporting system
hardware.

Packaging and Storage

When handling (installing, removing, examining) PCBs, do not touch the back
CAUTION!
(soldered) side or edge connector. Always hold the PCB by its edges.
➤
When packaging and storing the system, remove PCBs from the system cabinet (the power
supply may remain installed in the cabinet for storage and shipment). PCBs should be
packaged in their original antistatic bags for protection against electrostatic discharge. Be sure
to package equipment in its original shipping containers.

Site Requirements

This section defines the installation site requirements necessary to ensure a proper operating
environment for the DK14. Also included are grounding requirements.
environmental characteristics.)
Strata DK I&M 5/00
1
(Table 1-1 for electrical/
1-1