Operation - Panasonic KX-TDE100 Installation Manual

Pure ip-pbx
Hide thumbs Also See for KX-TDE100:
Table of Contents

Advertisement

5.1.3 Operation

PROBLEM
Cannot set the IP
address, subnet mask
address, and PBX IP
address to the IP-PT.
Cannot register the
IP-PT.
The IP-PT cannot
connect to the PBX.
Whenever you try to
make calls using a SIP
Extension, a busy tone is
heard.
When using the
speakerphone on an
APT, nothing is audible.
When using the
speakerphone/monitor
mode with a DPT,
nothing is audible.
The PT does not ring.
During a power failure,
extensions connected to
ports 1 to 4 of MSLC16/
CSLC16/SLC16 and
ports 1 to 2 of DHLC8/
SLC8 cards do not
operate.
PROBABLE CAUSE
An unusable value is
being set.
The necessary network
parameters are not set to
the IP-PT.
The wrong IP address,
subnet mask address,
PBX IP address, or
default gateway address
was entered.
The Ethernet cable is not
connected correctly.
The DHCP server is not
active.
The status of the port that
the SIP Extension is
connected to is Out of
Service.
The HANDSET/
HEADSET selector is set
to the "HEADSET"
position.
The "HEADSET" mode is
selected by Personal
Programming, "Handset/
Headset Selection".
The ringer volume is off.
A DPT or APT is
connected to the
extension port.
The dialling mode (tone
or pulse) is incorrect.
SOLUTION
Set an IP address within the valid range. IP
address of the IP-PT/PBX: "1.0.0.0" to
"223.255.255.255" Subnet mask address:
"0–255.0–255.0–255.0–255" (except
0.0.0.0 and 255.255.255.255)
When not using a DHCP server, set the IP
address, subnet mask address, and enter
the PBX IP address. If necessary, also
enter the IP address of the default gateway.
When using a DHCP server, enter the PBX
IP address.
Check each parameter and enter the
correct value.
Check the Ethernet cable connections.
Restart the DHCP server.
Disable DHCP and re-enter settings as
appropriate.
Change the port status from Out of Service
to In Service using the Maintenance
Console.
When the headset is not used, set the
HANDSET/HEADSET selector to the
"HANDSET" position.
When the headset is not used, select the
"HANDSET" mode by Personal
Programming.
Turn on the ringer volume.
Disconnect the DPT or APT and connect an
SLT.
Set the Tone/Pulse switch to the other
position.
5.1.3 Operation
Installation Manual
277

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pure ip-pbxKx-tde200Tde100Tde200

Table of Contents