Blocking Cooktop Sensors; Stop Function; Heat Sustainment Function; Power Function - Baumatic BSIH64-ANZ Instruction Manual

power level previously selected.
The time for pan detection is 3 minutes. If
a pan is not placed within this time period,
or the pan is unsuitable, the cooking zone
shuts off. The power indicator will go from
showing the symbol "there is no pan" to
showing 0.
When finished, turn off the coo-
king zone by using the touch controls.
Otherwise an undesired operation
could occur if a pan is accidentally pla-
ced on the cooking zone during the
next three minutes. Avoid possible
accidents!

Blocking cooktop sensors

BLOCK FUNCTION
With the Block Function, you can block the
other sensors, except for the on/off sensor
(1), in order to avoid undesired opera-
tions. This function is useful as a childpro-
of safety.
To activate this function, touch sensor
(6) for at least one second. Once you have
done so, the pilot (10) turns on indicating
that the control panel is blocked. To deac-
tivate the function, simply touch sensor
(6) again.
If the on/off sensor
off the appliance while the block function is
activated, it won't be possible to turn the
cooktop on again until it unblocks.

Stop Function

This function puts the cooking process on
pause. The timer will also be paused if it is
activated.
(1) is used to turn
Activating the Stop function
Touch the Stop sensor
second. The pilot (11) lights up and the
power indicators will show the symbol
to indicate cooking has been paused.
Deactivating the Stop function
Touch Stop sensor
(11) turns off and cooking resumes under
the same power and timer settings that
were established before the pause.

Heat Sustainment Function

This function makes it possible to keep
warm food that is in the pan placed on the
cooking area.
This function is independently available for
each one of the plates.
To activate it, select the plate. The decimal
point will light up. Then push sensor
(13). The symbol "A" will appear in the
indicator and the corresponding pilot (8)
will turn on.
To disconnect this function, all you have to
do is modify the power of the plate or
directly turn it off.
ower Function
This function supplies "extra" power to the
plate, above the nominal value. Said
power depends on the size of the plate,
(see values specified with * in the presen-
tation section), with the possibility of rea-
ching the maximum value permitted by the
generator.
1 Select the desired plate with the corres-
ponding sensor (3). The decimal point
will light up.
(7) for one
(7) again. The pilot
13