Pan Detector - Baumatic BSIH64-ANZ Instruction Manual

TURNING THE APPLIANCE ON
The first time the cooktop is plugged in (or
after a power outage), the Block function
will appear as activated (pilot light 10 on).
In this case, you must deactivate the block
function in order to turn the cooktop on. To
do this, push sensor
turns off.
1 Touch sensor
second.
Touch Control is now activated and a
appears in all power indicators (3). If a
cooking zone is hot, the corresponding
indicator will show an
vely.
Once the Control is on, you must activate
a plate within 10 seconds, otherwise the
Touch Control will automatically turn off.
While the touch control is activated, it can
be disconnected at any moment by tou-
ching the general on/off sensor
even if it has been blocked (see section
"Blocking cooktop sensors"). Sensor
(1) always has priority in disconnecting the
touch control.
ACTIVATING PLATES
Once the Touch Control is activated with
sensor (1), any plate can be turned on
by following these steps:
1 Select the plate by using the correspon-
ding sensor (3). In other words, press
with your finger the NUMBER INDICA-
TOR. If the glass is hot, the said indica-
tor will go from showing an H to showing
level 0. The decimal point to the bottom
right of the number lights up, indicating
that the plate has been selected.
12
(6) until pilot (10)
(1) for at least one
and a alternati-
H 0
2 Use the cursor slider (2) to choose a
cooking level between
As long as the plate is selected, in other
words, with the decimal point lit up, its
power level can be modified.
TURNING A PLATE OFF
A plate can be turned off by decreasing its
cooking level to
plate must have been previously selected
(decimal point lit up).
Once a plate has been turned off, an
0
appear on the corresponding power indi-
cator if the glass surface of the cooking
area reaches an elevated temperature.
Burn risk exists. When the temperature
decreases, the indicator turns off (if the
cooktop is disconnected), or it will show a
if it is still on.
0
TURNING ALL PLATES OFF
(1) All plates can be simultaneously discon-
nected by using the general on/off sensor
(1). All plate indicators will turn off.
Induction cooking zones have a built-in
pan detector. This way, the plate will stop
working if there is no pan present or if the
pan is not suitable.
The power indicator will show a symbol to
designate "there is no pan"
zone is on, no pan is detected or the pan
is not suitable.
If a pan is taken off the zone while it is run-
ning, the plate will automatically stop
supplying energy and it will show the
symbol for "there is no pan". When a pan
is once again placed on the cooking zone,
energy supply will resume at the same
and
0
. In order to do this, the
0

Pan detector

.
9
will
H
if, while the