Sony CDX-GT430U Operating Instructions Manual page 17
Fm/am compact disc player
Hide thumbs
Also See for CDX-GT430U:
- Installation/connections (2 pages) ,
- Operating instructions manual (112 pages) ,
- Specifications (3 pages)
Table of Contents
Advertisement
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, demonstration
mode starts.
If no operation is performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
-Set "DEMO-OFF' (page 12).
The display disappears from/does not appear
in the display window.
• The dimmer is set "DIM-ON" (page 12).
• The display disappears if you press and hold
(OFF).
-
Press and hold
(OFF)
on the unit until the
display appears.
• The connectors are dirty (page IS).
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
- Turn off the unit.
.,
~g. pl'I~"~~hi1~~~%11t~i;&iii{;.~)J:i:'J1;,~,'~;i:!;§Zflt~~
The disc cannot be loaded.
• Another disc is already loaded.
• The disc has been forcibly inserted upside down or in
the wrong way.
The disc does not playback.
• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 14).
MP3IWMAlAAC files cannot be played back.
The disc is incompatible with the MP3IWMAlAAC
format and version. For details on playable discs and
formats, visit the support site.
MP3IWMAlAAC files take longer to play back
than others.
The following discs take a longer time to start
playback.
- a disc recorded with a complicated tree structure.
- a disc recorded in Multi Session.
- a disc to which data can be added.
The display items do not scroll.
• For discs with very many characters, those may not
scroll.
• "A.SCRL" is set to "OFE"
-Set "A.SCRL-ON" (page 13).
-
Press and hold (
DSPL)
(SCRL).
The sound skips.
• Installation is not correct.
-
Install the unit at an angle of less than 45° in a
sturdy part of the car.
• Defective or dirty disc.
The operation buttons do not function.
The disc will not eject.
Press the RESET button (page 4).
The stations cannot be received.
The sound is hampered by noises.
The connection is not correct.
-Connect a power antenna (aerial) control lead
(blue) or accessory power supply lead (red) to the
power supply lead of a car's antenna (aerial)
booster (only when your car has built-in FM/AM
antenna (aerial) in the rear/side glass).
-Check the connection of the car antenna (aerial).
-
If the auto antenna (aerial) will not go up, check the
connection of the power antenna (aerial) control
lead.
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
• Setting of the local seek mode is not correct.
-
Tuning stops too frequently:
Set "LOCAL-ON" (page 13).
-
Tuning does not stop at a station:
Set "LOCAL-OFF' (page 13).
• The broadcast signal is too weak.
-
Perform manual tuning.
During FM reception, the
"ST"
indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
-Set "MONO-ON" (page 13).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
-Set "MONO-OFF" (page 13).
The USB device takes longer to play back.
The USB device contains files with a complicated tree
structure.
A beep sounds.
During playback, the USB device has been
disconnected.
-
Before disconnecting a USB device, make sure to
stop playback first for data protection.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate of
more than 320 kbps.
-
Page 17
Advertisement
Table of Contents
