Miele WS 5426 MC 13 Operating And Installation page 33

Fault
The check light p
flashes, the r End
indicator light is on,
but the laundry in
the machine has
not been washed.
The indicator
q
light is flashing.
The programme se-
quence indicator
light Pre-Wash is
i
flashing.
The programme se-
quence indicator
light Main wash
j
flashes during or at
the end of a pro-
gramme.
The programme se-
quence indicator
light Rinse 1 or
n
Rinse 2 flashes.
n
Possible cause
The water inlet is
blocked.
The drainage
system is blocked.
There is a fault.
There is a fault.
There is a fault.
Problem solving guide
Remedy
– Turn the programme selector to
r End.
– Open the stopcock(s).
– Select a programme.
– Press the h Start button.
If little or no water is taken in during
the next programme, the water
pressure may be too low. If it is
adequate there may be a technical
fault. In this case, call the Miele
Service Dept.
Check whether
– the drainage system is blocked,
See "Cleaning the drainage
system" in "Cleaning and Care".
Start the programme again.
If the indicator light flashes again,
call the Miele Service Dept.
If the indicator light flashes again
when the next programme is run,
call the Miele Service Dept.
Start the programme again.
If the indicator light flashes again,
call the Miele Service Dept.
33