Advertisement
6. Insert each wire into the appropriate hole and
snap down the locking tabs.
7. Insert the smooth side of the connector plug into
the smooth side of the AB50-X2 socket.
8. Connect the variable line level output of the TV to
the RCA terminals labeled INPUT.
9. Connect the TV power cord to the terminal
labeled CURRENT SENSING AC OUTLET.
10. Connect the Multizone Receiver wires to the
terminal labeled SPEAKER A IN.
11. Connect the Speaker wires to the terminal
labeled SPEAKER A OUT.
12. Plug the AB50-X2 power cord into the un-
switched AC outlet and adjust the current
sensing, using the sensitivity adjustment screw
located on the bottom of the unit.
13. Mount AB50-X2 to determined location.
See figure 3.
See Installation diagram on page 6.
Figure 3
5
Advertisement
