Settings And Operation - AEG Thyro-A Operating Instructions Manual

Thyristor power controller
Hide thumbs Also See for Thyro-A:
Table of Contents

Advertisement

4. Settings and operation

• Observe all safety regulations in the chapter on safety.
Setting and operating the thyristor power controller is described in this
chapter.
There are three ways of setting the power controller:
• on DIP switches and potentiometers (on device)
• via bus system (when operated in a bus system)
• via PC interface and THYRO-TOOL FAMILY
Certain settings can only be made on the device (DIP switch S1.7, S1.8
and S1.10), e.g. setting the analog input and output.
In the case of certain configurations / connection types, setting on the
device itself is no longer possible:
• Operation with bus module (see also page 64, Connecting the bus
module)
- Ground to X22.1: Setpoint comes from bus. DIP switch and potenti-
ometer are read in once after being switched on and the setting can
then be changed with the bus module.
- No ground to X22.1: DIP switch and potentiometer are always read
in. Setpoint is read via the analog input.
• Operation with THYRO-TOOL FAMILY
- Device in Thyro-Tool mode: DIP switch and potentiometer are igno-
red. Settings are read out of the memory and can only be changed
via the PC.
- Device not in Thyro-Tool mode: DIP switch and potentiometer are
read in. Further settings can be changed via the PC. All parameters
are visualized on the PC.
DANGER
Dangers involved in settings and operation
Risk of injury / Risk of damage to the device or plant
NOTE
Described settings
Settings made on the device itself are described in this
chapter. Where reference is made to settings with a bus
module or with the PC, this is indicated
36

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thyro-a series

Table of Contents