Miele WS 5427 MC 23 Operating And Installation Instructions page 32

Problem solving guide
Fault
The check light p
flashes, the r End
indicator light is on,
but the laundry in
the machine has not
been washed.
The q indicator
light is flashing.
The programme se-
quence indicator
light i Pre-Wash is
flashing.
The programme se-
quence indicator
light j Main wash
flashes during or at
the end of a
programme.
The programme se-
quence indicator
light n Rinse 1 or
n Rinse 2 flashes.
32
Possible cause
The water inlet is
blocked.
The drainage sys-
tem is blocked.
There is a fault.
There is a fault.
There is a fault.
Remedy
– Turn the programme selector to
r End.
– Open the stopcock(s).
– Select a programme.
– Press the h Start button.
If little or no water is taken in during
the next programme, the water
pressure may be too low. If it is ade-
quate there may be a technical
fault. In this case, call the Miele Ser-
vice Dept.
Check whether
– the drainage system is blocked,
See "Cleaning the drainage sys-
tem" in "Cleaning and Care".
Start the programme again.
If the indicator light flashes again,
call the Miele Service Dept.
If the indicator light flashes again
when the next programme is run,
call the Miele Service Dept.
Start the programme again.
If the indicator light flashes again,
call the Miele Service Dept.